Ignition Coils, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove and disconnect the connector -2- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2-, free up the ground wire -1- and remove the double bolt -3- from underneath.

Courtesy of AUDI OF AMERICA, LLC

-- Release the connectors and simultaneously disconnect them from the ignition coils in the direction of -arrow-.

-- Insert the :T10530 in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise in direction of -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using the :T10530 .

Fig 2: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC