Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, BOLTED VERSIONS: Removing
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the screw-type clamp -2-, remove the air duct pipe from the Throttle Valve Control Module -GX3- and slightly push it to the left side.
-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the : VAS6122 .
-- Disconnect the connector -1-.
-- Remove the bolt -2- and remove the Charge Air Pressure Sensor -G31- from the air duct pipe.