Crankshaft, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is removed and secured to the engine/transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Remove the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .
-- Remove the left engine support. Refer to LEFT ENGINE SUPPORT, REMOVING AND INSTALLING .
-- Mark the installation position and which connecting rod bearing cap -1- belongs to which connecting rod -item- 2.
-- Remove the bolts -arrows- and remove the connecting rod bearing cap.
- Do not damage the cracked surfaces of the connecting rods and connecting rod bearing caps.
-- Remove the bolts -arrows- and -1 through 10-.
-- Remove the bearing cap using the :T10055 .