Transmission Mount, Removing And Installing, Version 2
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Transmission Support, Removing with Transmission Mount
-- Remove the tunnel crossmember. Refer to the appropriate service information .
-- Remove the bolts -arrows- and remove the transmission support with the transmission mount from the transmission.
Transmission Mount, Removing
-- Remove the bolts -1- and remove the stop -2- for the transmission mount.
-- Remove the nut -4- and the bolt -5-, and remove the transmission mount -6- from the transmission support -3-.
Installing
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
-- First tighten the nut -4- and bolt -5- hand-tight.
-- Tighten the bolts -1- for the stop -2-.
-- Then tighten the nut -4- and bolt -5-.
Tightening Specifications
- Refer to the appropriate service information .