Overview - Engine Mount
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Subframe
- Bolt
- 20 Nm
- Bolt
- 10 Nm
- Support Bearing
- Removing and Installing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- Bolt
- 55 Nm
- Engine Support
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Heat Shield
- Bolt
- 10 Nm
- Bolt
- 55 Nm
- Engine Mount
- With
- Left Electrohydraulic Engine Mount Solenoid Valve -N144-
- Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- The solenoid valve is integrated in the engine mount; cannot be replaced separately if faulty
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- With
- Bolt
- 90 Nm + 90°
- Replace after removing
- Bolt
- 30 Nm
Support Bearing, Installation Position
- The raised section -2- of the engine support must engage into the opening -1- on the support bearing.