LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Sunroof (Fy & 87)) >> 60 Sunroof >> Sliding Sunroof >> Glass Panel, Removing And Installing >> Glass Panel, Removing And Installing, Rear >> Installing

Glass Panel, Removing And Installing, Rear: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Remove any locking fluid residue from the threaded hole using a thread tap.

-- Install the rear glass panel bolts, but do not tighten.

-- Adjust the rear glass panel (refer to GLASS PANEL, ADJUSTING ), then tighten the bolts.

-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .

scientia non olet · About LEMON Manuals