INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING, WITH DRIVER INFORMATION SYSTEM: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.

-- Switch off the ignition and place the ignition key outside of the vehicle.

-- Remove the driver side instrument panel vent. Refer to OUTER INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the center and front passenger side instrument panel vent. Refer to CENTER VENT, REMOVING AND INSTALLING .

-- Remove the bolts -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the instrument cluster trim -3- by releasing the catch -1- in direction of -arrow-.

-- Remove the bolts -1 and 4-.

Courtesy of AUDI OF AMERICA, LLC

-- Guide the :T40207 between the instrument panel and instrument cluster and attach it in the center as shown -3-.

-- Using the :T40207 , remove the instrument cluster -2- from the retainer -arrow- and tilt toward the rear.

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Equipped on some models: disconnect the connector -2- for the fiber-optic cable.

-- Seal the open wiring harness connector -2- of the fiber-optic cable with the : VAS6223/9 -1-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

TIP:

The protective cap prevents contamination of or mechanical damage to the front surface of the fiber-optic cable which would impair light transmission.

-- Remove the instrument cluster on the front passenger side between the steering wheel and the instrument panel.