Rear Parking Aid Sensor, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Exterior Sensors:

-- Right side of the vehicle with TDI engine or LTE antenna: remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Reach behind the bumper cover and expand both tabs in direction of -arrows- while pushing the sensor -3- from the outside toward the inside at the same time.

Fig 1: Pressing Both Catches -Arrows - To Side And Press Sensor -3- Inward From Outside

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.

Interior Sensors:

Courtesy of AUDI OF AMERICA, LLC

-- Right center sensor on versions with trailer hitch: extend the trailer hitch.

-- Remove the bolts -arrows- on the lower section of the bumper cover.

-- Press both tabs to the side in direction of -arrows- and at the same time, push the sensor -3- through from the outside toward the inside.

Fig 2: Pressing Both Catches -Arrows - To Side And Press Sensor -3- Inward From Outside

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.