Sill Panel Trim, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Equipment version with illuminated sill panel trim:
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the lower B-pillar trim. Refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Lift the carpet slightly and disconnect the connector -3-.
-- Free up the wire by slightly pulling the seal -2- away from the body flange.
Continuation:
-- Vehicles without cut-outs for pin in the side sill: make the position of the sill panel for installation.
-- Carefully warm up the sill panel trim -1- using the :VAG1416 .
-- Carefully pry the sill panel trim from the side sill in direction of -arrow- using the :3409 . Do not damage the paint coat while doing so.