Oil Pan Lower Section, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Engine oil drained. Refer to ENGINE OIL .

-- If installed, remove the bolt -1- and move the bracket -2- and wiring harness to the side.

Fig 1: Identifying Wiring Harness Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- on the Oil Level Thermal Sensor -G266-.

Fig 2: Oil Pan Lower Section - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wires.

-- Loosen and remove the bolts in the following sequence: -17 to 1-.

-- Loosen and remove the oil pan lower section carefully from the bonding.