Overview - Cylinder Block, Belt Pulley Side, A/C Compressor Belt Drive, 3.0L Engine
WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Cover
- For the idler roller
- Bolt
- 25 Nm
- Idler Roller
- For the ribbed belt
- Ribbed Belt
- Check for wear
- Do not kink
- Belt path. Refer to Fig 2.
- Before removing, mark the running direction using chalk or a felt-tip pen.
- Removing and installing. Refer to RIBBED BELT FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 3.0L ENGINE .
- When installing, make sure it is seated correctly on the belt pulleys
- Cover
- For the tensioner
- Bolt
- 25 Nm
- Tensioner
- For the ribbed belt
- Removing and installing. Refer to RIBBED BELT TENSIONER FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 3.0L ENGINE .
- Bolt
- Tightening specification -item- 15
- Vibration Damper
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Alignment Sleeve
- Quantity: 2
- Bracket
- For the A/C compressor
- Removing and installing. Refer to A/C COMPRESSOR BRACKET, REMOVING AND INSTALLING, 3.0L ENGINE .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
- Always replace after removing.
- A/C Compressor
- Removing and installing. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .
- Bolt
- Tightening specifications. Refer to OVERVIEW - A/C COMPRESSOR POWER UNIT .
- Alignment Sleeves
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
A/C Compressor Belt Path, 3.0L Engine
- Vibration Damper
- Ribbed Belt Tensioner
- A/C Compressor
- Idler Roller
A/C Compressor Bracket - Tightening Specifications and Sequence, 3.0L Engine
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in stages as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -2 and 3- | Install by hand all the way |
| 2. | -2 and 3- | 8 Nm |
| 3. | -2- | 90° additional turn |
| 4. | -3- | 90° additional turn |