Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine and Transmission Holder:VAS6095A
Engine/Transmission Holder - Universal Mounting:VAS6095/1
Engine/Transmission Holder - V6 TFSI Bracket:VAS6095/1-15

Procedure

-- Remove the bolts -arrows- and remove the left engine support.

Courtesy of AUDI OF AMERICA, LLC

If the Chain Drive on the Connection Should Be Worked On:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2- at the same time to not damage it.

-- Free up the wiring harness -3-.

-- Remove the nuts -4- and bolt -5-.

-- Remove the vacuum reservoir -1-.

-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC

Continuation:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ground cable nut -arrow-.

-- Remove the bolts -arrows- and remove the right engine support -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .

-- Secure the engine to the :VAS6095A using the :VAS6095/1-15 and :VAS6095/1-11 and tighten to 40 Nm.

Courtesy of AUDI OF AMERICA, LLC