LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (General Information) >> General Information >> Maintenance Work >> Connected Gateway, Replacing Emergency Battery >> Removing

Connected Gateway, Replacing Emergency Battery: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition and all electrical equipment and remove the ignition key.

-- Remove the bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

The Data Bus on Board Diagnostic Interface -J533- must not be removed.

-- Release the retainers and remove the cover upward from the Data Bus on Board Diagnostic Interface -J533- -1- in the direction of -arrow-.

Fig 1: On Board Diagnostic Interface -J533-
GWWA91-12580Courtesy of AUDI OF AMERICA, LLC

-- Pivot out the Telematics Emergency Battery -- -1- from the Data Bus on Board Diagnostic Interface -J533-.

Fig 2: Telematics Emergency Battery -A16-
GWWA91-12581Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector.