Wheel Electronics, New Version

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Install the same wheel electronics for all four wheels.

CAUTION:

If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.

Special tools and workshop equipment required

Torque Wrench 1410: VAG1410 and Torque Wrench 1410 Insert - Accessory Kit: VAG1410/1

Fig 1: Identifying Torque Wrench VAG 1410
Courtesy of AUDI OF AMERICA, LLC

Union nut 4 Nm

-- Fold the valve -1- downward -arrow A toward B-.

Courtesy of AUDI OF AMERICA, LLC

-- Slide the valve with the wheel electronics attached through the valve opening in the rim.

-- Rotate the union nut -2- three turns on the valve -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the union nut -2- until the bar breaks with an audible snap.

NOTE:

Press the wheel electronics -1- firmly on the rim well at the same time so that it rests securely on the rim well.

-- Tighten the union nut to 4 Nm.