Valve, Removing And Installing, Metal Valve: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only apply the specified torque to tighten the nut for the metal valve.
Tightening more is not permitted because it damages the seal.
-- Tighten the nut -1- of the metal valve.
-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.
-- Install the Tire Pressure Monitoring Sensor --.
-- Fill the tire to the specified pressure.
CAUTION:
Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseperable connection and cannot be separated again.