Boot, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the boot after removal.

CAUTION:

Risk of damaging the boot due to improper handling.

Do not crush the boot folds.
Do not bring the boot into contact with hard or sharp objects.

-- Check the seating of the boot on the steering gear for damage. Replace the steering gear if the seal seat is damaged.

-- Coat the seating of the inner boot all around and evenly with Steering Gear Grease:G 052 168 A1 .

-- Coat the steering rack on toothed side -A- and on the thrust piece side with Steering Gear Grease:G 052 168 A1 by turning the steering all the way in the corresponding direction.

Fig 1: Identifying Steering Rack Toothed Side -A-

Courtesy of AUDI OF AMERICA, LLC

-- Bring wheels in the straight position.

Fig 2: Identifying Power Steering Gear Boot

Courtesy of AUDI OF AMERICA, LLC

-- Slide the boot onto the steering gear housing with a new clamp.

-- Make sure that the boot is seated correctly.

The boot must fit in the groove and on the steering gear.

-- Tension the inner clamp -1-. Refer to Figure.

-- Secure the spring clip -3- on the boot -2- with the :VAS6362 , and pay attention to the installation position at the same time. Refer to Figure.

Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .