Active Steering Safety Lock (Locking Solenoid), Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
The installation of a new adjusting element of the reinstallation of a marked adjusting element takes place in reverse order, at the same time note the following:
-- Place the marked adjusting element according to the mark applied during removal and tighten (use the socket included in the repair kit).
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Suspension
- Steering
- 0001 - OBD-capable systems
- 001B - Active Steering Control Module - J792
- 001B - Active Steering Control Module functions J792
- 001B - Basic setting (rep.gr.48)
- 001B - Basic setting complete
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.