SUBFRAME Rear Bonded Rubber Bushing, Replacing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the anti-twist mechanism -1- in the area of the retaining tabs -arrows- with a screwdriver from the bonded rubber bushing alternating from side to side.

-- Pry out the plastic insert from the bonded rubber bushing.

-- Arrange the special tools as shown.

Courtesy of AUDI OF AMERICA, LLC

:T10205/8-1
:VAS6178
:T40328/3
:T40328/5
Bonded Rubber Bushing
:T40328/6
:T10205/8-2

-- Align the bonded rubber bushing with the markings made previously and push it in until the collar comes in contact with the bushing in the subframe without any gaps.

NOTE:

If necessary, tension and press over cylinder several times.

To prevent damage to the outer race, while pushing in, pay attention that the bonded rubber bushing is not tilted.

The ends of the rubber bead on the bonded rubber bushing must align with the markings -arrows- on the subframe.

Fig 1: Ends Of Rubber Bead On Bonded Rubber Bushing Must Align With Markings
Courtesy of AUDI OF AMERICA, LLC

NOTE:

Correct any paint damage on subframe with corrosion protection, primer and black top coat.

-- Install the plastic insert and the anti-twist mechanism on the hydraulic bonded rubber bushing.

Further installation is the reverse order of removal.