Stabilizer Bar, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Before starting work:

-- Versions with coil springs: determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

-- Versions with air suspension: determine the standard vehicle height. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the lower longitudinal member. Refer to OVERVIEW - LOCK CARRIER .

-- Insert the :T40335 on the left and right side into the subframe. If necessary, adjust the brace at the knurled handle.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the brace on the left and right side using a cotter pin -arrow-.

-- Remove the left and right nuts -arrows and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right clamp -1- and bolt -4-.

-- Remove the stabilizer bar -2-.