Coupling Rod, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the threaded connections for the components with bonded rubber bushings only until the stop, but do not tighten yet.
NOTE:
Bonded rubber bushings have a limited range of rotation. Only tighten suspension screws when vehicle is in curb weight position or at standard vehicle height.
-- Lifting the wheel bearing in curb weight position (refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING ) or at standard vehicle height (refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION ).