Cover And Cushion, Removing And Installing, Folding Backrest: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear headrest. Refer to HEADREST, REMOVING AND INSTALLING .

-- Remove the locking mechanism trim. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .

Low Rear Seat:

-- Remove the rear seat backrest. Refer to OUTER REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Unclip the outer bearing sleeve -1- from the rear seat backrest with the :T10383/1  -arrow-.

High Rear Seat:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the single seats. Refer to SINGLE SEATS, REMOVING AND INSTALLING .

-- If installed, free up the wire -3- for the backrest heating element.

-- Unclip the expanding clips -arrows- for the rubber straps -2- for the backrest cover using the :80-200  on the bottom of the seat frame.

Continuation for All Seat Versions:

Fig 1: Prying Off Clamping Strip -2- For Backrest Cover Using A Screwdriver All Around Backrest Frame -3- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Starting at the locking mechanism, use a screwdriver to pry off the clamping strip -2- for the backrest cover all around the backrest frame -3- -arrow-.

-- Remove the rear headrest guides. Refer to HEADREST GUIDE, REMOVING AND INSTALLING .

-- Remove the backrest cover -1- and backrest cushion from the backrest frame.