LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Pedestrian Protection >> Overview - Pedestrian Protection

Overview - Pedestrian Protection

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
GWWA69-11363Courtesy of AUDI OF AMERICA, LLC
  1. Driver Side Pedestrian Protection Crash Sensor 2
    • LHD in the direction of travel on the left side: Driver Side Pedestrian Protection Crash Sensor 2 -G851-
    • LHD in the direction of travel on the right side: Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
    • Unit with pressure hose
    • Component location: in the molded foam part on the impact member
    • Must be replaced when
      • The molded foam part is visibly damaged.
      • The impact member is visibly deformed.
      • Bumper cover very damaged / visibly damaged
      • The pressure hose is damaged.
    • Place the pressure hose in the groove on the molded foam part.
    • Insert the pressure hose in the molded foam part, excess pieces are routed without kinks in the balancing zones
    • Do not kink or squeeze the pressure hose.
    • Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR, REMOVING AND INSTALLING .
  2. Pedestrian Protection Center Crash Sensor -G693-
  3. Pedestrian Protection Trigger in Direction of Travel on the Right Side
    • LHD: Pedestrian Protection Trigger 2 -G599-
  4. Clip
  5. Seal
  6. Seal
  7. Clip
  8. Pedestrian Protection Trigger in Direction of Travel on the Left Side
    • LHD: Pedestrian Protection Trigger 1 -G598-
  9. Screw
    • 6 Nm
scientia non olet · About LEMON Manuals