Passenger Occupant Detection System, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Pry Lever:80-200
- Engine/Transmission Holder - Seat Repair Fixture:VAS6136
- The passenger occupant detection system is only installed in the passenger seat.
- The service kit for the passenger occupant detection system must always be installed completely.
- This means that the components that belong together from the passenger occupant detection system service kit (Passenger Occupant Detection System Control Module -J706- and Front Passenger Occupant Detection Sensor -G128-) must always be installed.
- Exchanging of a component Passenger Occupant Detection System Control Module - J706- or Front Passenger Occupant Detection Sensor -G128- with another vehicle is not permitted.
- The parts of the service kit are different depending on the seat version. Refer to the Parts Information.