Component Location Overview - Passenger Occupant Detection System
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Wiring Harness
- For the seat position sensor/seat belt fastening detection/seat belt switch
- Clip into the seat frame
- Black connector, connector station in the vehicle floor under the seat
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Wiring Harness
- For the seat heating element with passenger occupant detection system
- Clip into the seat frame
- Green connector, connector station in the vehicle floor under the seat
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Control Module Bracket
- Clip into the seat frame
- Front Passenger Occupant Detection Sensor -G128-
- The seat heating element is used for the passenger occupant detection system.
- Depending on the seat version, the Front Passenger Occupant Detection Sensor -G128- is either sewn into the cover with the seat heating element, or bonded onto the seat cushion
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Nut
- 1.5 Nm
- Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to -item- 4.