Glove Compartment Handle Lock Cylinder, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the glove compartment handle. Refer to GLOVE COMPARTMENT HANDLE, REMOVING AND INSTALLING .
-- Drive out the axle -1- from the locating bore with a punch in the direction of -arrow-.
-- Remove the cover -2-.
CAUTION:
Risk of destroying the lock cylinder.
- The lock cylinder may only be removed and installed with the key properly inserted to prevent the tumblers and pressure springs from falling out.
-- Insert the key -4- into the lock cylinder.
-- Carefully release the catches -1 and 2- one after the other using a small screwdriver and remove the lock cylinder -3- at the same time in direction of -arrow-.
NOTE:
The retainers -1 and 2- cannot be released without damaging them.