Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Clean bolts before reusing.

Replacing the damaged bolts. Refer to the Parts Information.

Always replace the self-locking bolts. Refer to the Parts Information.

NOTE:

Replace the seal after removal.

The ring groove for the gasket and the parking brake motor contact surface must not be damaged.

-- Clean the parking brake motor ring groove and contact surface.

-- Install the new seal.

NOTE:

Make sure that the gasket is not removed while assembling the parking brake motor.

Courtesy of AUDI OF AMERICA, LLC

-- Bring the parking brake motor -1- into the installation position while turning the parking brake motor back and forth slightly.

-- Tighten the bolts -arrows-.

The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.

CAUTION:

There is a risk of damaging the threads.

Position the bolts by hand and screw in a few turns.
If the thread is damaged, the entire brake caliper must be replaced.

-- Perform a basic setting after installing:

Fig 1: Connecting Diagnostic Cable VAS 5051/5A To Diagnostic Connector

Courtesy of AUDI OF AMERICA, LLC

-- Connect the Vehicle Diagnostic Tester to the vehicle diagnostic connection when the ignition is switched off.

-- Switch the ignition on.

-- Select Diagnostic and start.

-- Select the Test plan tab.

-- Select the button Select individual tests... and select the following tree structures one after the other:

Chassis
Brake system
01 - OBD-capable systems
03 - ABS Control Module J104 integrated parking brake
03 - Electric parking brake functions
03 - Basic setting

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

WARNING:

Risk of accident!

Make sure the brakes are working correctly before driving the vehicle for the first time.