Vacuum Pump, Removing And Installing, 3.0L TFSI Engine: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
Do not damage the vacuum line.
A damaged vacuum line must be replaced.
Replace the seal -3- after removal.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.
Tighten the bolts for the vacuum pump to 9 Nm.
-- Install the vacuum line with the hose clamp -1- connected.
-- Install the lower air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .