Vacuum Pump, Removing And Installing, 3.0L TDI Engine: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the seals.
Make sure the seals are in the correct installation position.
-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.
-- Install vacuum pump.
-- Install and tighten all the bolts -arrows- on the vacuum pump sealing flange to 9 Nm.
-- Slide the new clamp over the vacuum hose.
-- Press the vacuum hose onto the vacuum pump connection.
CAUTION:
Do not damage the vacuum hose. Replace the vacuum hose if damaged.
-- Close the new clamp on the vacuum hose with pliers.
-- Install the right diagonal tower brace.
-- Install the engine cover.