Vacuum Pump, Removing And Installing, 2.0L TDI Engine: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the seals.

Make sure the seals are in the correct installation position.

-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.

-- Install vacuum pump.

-- Install and tighten all the screws on the vacuum pump sealing flange OVERVIEW - VACUUM PUMP => List Item: TORX 30 bolt (quantity: 2).

NOTE:

Install the two nuts under the pressure sensor bracket and tighten.

-- Slide the new clamp over the vacuum hose.

-- Connect the vacuum hose to the vacuum pump.

-- Close the hose clamp with pliers.

-- Push the coolant pipe over the vacuum pump stud.

-- Install the diesel particulate filter pressure sensor bracket to the vacuum pump.

-- Tighten the bracket.

-- Install the pressure sensor lines into the bracket.

-- Install the pressure sensor.

Fig 1: Identifying Diesel Particulate Filter Pressure Sensor -1-, Pressure Sensor -2-

Courtesy of AUDI OF AMERICA, LLC

-- Install the engine cover.