Overview - Rear Brake Caliper
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When servicing, always install entire repair kit.
- 1 -
Self-Locking Screw
- Always replace.
- Counterhold at the guide pin when loosening and tightening.
- 35 Nm
- 2 -
Brake Caliper Housing with Actuator
- 3 -
Bleeder Valve
- 10 Nm
- 4 -
Dust Cap
- Push onto breather valve
- 5 -
Seal
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- 6 -
Thrust Nut
- to operate parking brake
- 7 -
Piston
- BRAKE CALIPER PISTON, REMOVING AND INSTALLING
- Coat with a thin layer of lithium grease. Refer to Parts Catalog
- 8 -
Guide Pin
- Grease before installing the protective cap
- Delivered as a replacement part with sufficient grease.
- Refer to PROTECTIVE CAP AND GUIDE PINS, REPLACING
- 9 -
Protective Cap
- Pull onto the brake carrier and guide pin.
- Refer to PROTECTIVE CAP AND GUIDE PINS, REPLACING
- 10 -
Brake Carrier with Guide Pins and Protective Cap
- Delivered as an assembled replacement part with sufficient grease on the guide pins
- Install the repair kit if the caps or guide pins are damaged. Use grease packet supplied to lubricate guide pins.
- 11 -
Protective Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- Pull onto the piston with the outer sealing lip.