Accelerator Pedal Module -GX2-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Engage the bottom of the accelerator pedal module on the pedal bracket, insert the centering pin and tighten the bolt.
NOTE:
Depending on the engine/transmission combination, an adaptation must be performed after replacing.
If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.