Trailer Hitch Socket, Removing And Installing - Version 4: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Trailer Hitch -1-, Bolts -2- and Cable Tie -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

During installation, install the cable ties at the same location.

-- Turn off the ignition and all electrical equipment.

-- Move out the trailer hitch.

-- Cut through the cable tie -3-.

-- Remove the bolts -2-.

-- Remove the socket from the trailer hitch -1-.

-- Release the retainers -arrows-.

Fig 2: Identifying Socket Cap -1- and Rubber Cover -2-

Courtesy of AUDI OF AMERICA, LLC

-- At the same time remove the cap -1- from the socket.

-- Remove rubber cover -2-.

-- Release the clips in direction of -arrows- and press multiple connector -2- out of socket -1-.

Fig 3: Releasing Retaining Clips -Arrows- To Press Multiple Connector -2- Out Of Socket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips in direction of -arrows- and remove retainer -1- from multiple connector -3-.

Fig 4: Releasing Retaining Clips -Arrows- To Remove Retainer -1- From Multiple Connector -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Carefully remove the retainer so that contacts -2- of the multiple connector are not disconnected from the wiring harness.