Trailer Hitch Socket, Removing And Installing - Version 2: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cable Tie -1-, Screws -2- & -4- And Trailer Hitch -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

During installation, install the cable ties at the same location.

-- Turn off the ignition and remove the key.

-- Unfold and engage the trailer hitch.

-- Cut the cable tie -1- and remove the screws -2 and 4-.

-- Press the socket out of trailer hitch -3- in direction of -arrow-.

-- Turn cap -1- counterclockwise -arrow- and remove it from socket -3-.

Fig 2: Turning Cap -1- Counterclockwise -Arrow- To Remove It From Socket -3-

Courtesy of AUDI OF AMERICA, LLC

-- Remove rubber cover -2-.

-- Release the retaining clips -arrows- and press multiple connector -2- out of socket -1-.

Fig 3: Releasing Retaining Clips -Arrows- To Press Multiple Connector -2- Out Of Socket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release the retaining clips -arrows- and remove retainer -1- from multiple connector -3-.

Fig 4: Releasing Retaining Clips -Arrows- To Remove Retainer -1- From Multiple Connector -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Carefully remove the retainer so that contacts -2- of the multiple connector are not disconnected from the wiring harness.