2021 Q5 / Q5 PHEV / Sq5

WARNING: This page is about a different car, the 2021 Audi SQ5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Audi Pre-Delivery Inspection


_{Stock Number}	_{Dealer Number}	_{R.O. Number}

_VIN	_{Road Test Mileage Out}	_{Road Test Mileage In}

Reminders

→ All items must be completed prior to customer delivery by a certified Audi technician

→ Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection

→ Guided Fault Finding must be used, session must be completed and sent to GFF Paperless

→ Total PDI Test must be completed prior to any other work involving the scan tool (special function tab -> Total PDI Test)

→ Start Guided Fault Finding with the engine running to ensure control modules in transport mode are identified

→ For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information

→ For items marked with **, follow instructions for stock inventory vehicle

√ all completed items
Vehicle Preparation
□	Check Elsa for open campaigns and updates
□	Perform any open campaigns*
□	Verify Audi phone box customer registration form is present in vehicle and add the serial number from Elsa (if equipped). See TSB 2051720
□	Set adaption channel to enable CD Ripping using Guided Functions (if equipped with NAV)*
□	Perform any open campaigns*
□	Perform diagnostic work*
□	Install front license plate carrier (if necessary)*
Exterior
□	Check all key buttons and features*
□	Check all doors for proper power closing (if equipped)*
□	Inspect exterior for damage, dings, dents and surface scratches. Report and repair any damage before delivery to the customer
□	Prepare the base bars for customer delivery (install bars only upon customer request)*
Lighting and Windshield
□	Test exterior lighting functions
□	Test windshield washers. Correct aim if necessary*
Trunk Inspection
□	Verify power tailgate is operational and set default opening height*
□	Install wheel bolt cover removal tool from PDI kit into trunk tool kit*
□	Verify tool kit is installed securely in luggage compartment
□	Verify inflatable repair kit and compressor are present
□	Set spare tire pressure*
□	Check battery clamps for proper torque*
□	Verify operation of luggage cover
Interior
□	Verify operation of all seat belts and latches
□	Check operation of window, lock, and seat controls*
□	Inspect mirrors for proper operation*
□	Check rear view mirror operation*
□	Verify operation of all interior lights
□	Check heated steering wheel operation (if equipped)
□	Verify operation of heated seats
□	Verify operation of ventilated seats (if equipped)
□	Verify operation of rear heated seats (if equipped)
□	Verify operation of manual folding 2nd row
□	Verify proper operation of climate control*
□	Inspect operation of all power outlets*
□	Check panoramic sunroof and sunshade operation (if equipped)*
□	Verify the glove compartment opens and closes properly
□	Verify operation of front Passenger Occupant Detection System
Settings
□	Verify operation of MMI® touch pad (if equipped)
□	Set time source setting to "GPS" and set auto daylight savings time to "on" *
□	Set Time to "Automatic setting" and "Automatic time zone"
□	Verify and set language and measurement units* - For the Q5 TFSI e: Go to the Menu - MMI Settings - Measurement Units - E-motor consumption - change to mi/kWh
□	Verify Speech Dialog System is operating*
□	Set "Entertain. Fad." in parking aid to an audible level*
□	Set "Music volume while parking" to 6 lines*
□	Set dealership location in navigation (if equipped)*
□	Turn off Manual Speed Warning (if equipped)*
Media / Radio / SAT
□	Verify operation of all USB ports
□	Verify operation of AMI or aux. input (if equipped)
□	Verify operation of CD / DVD player (if equipped)
□	Insert SD card and test function of slots
□	Program the presets to local stations
□	Verify HD Radio_TM is turned "off"*
Audi connect® (USA ONLY) (if equipped)
□	Turn on the Wi-Fi® hotspot (if equipped)*
□	Check Wi-Fi® hotspot visibility. No data available at PDI (if equipped)*
□	Enable Google Earth view for navigation (if equipped)*
On-Hoist Inspection
□	Remove transport suspension blocks (follow ELSA instruction)
□	Check steering, boots, brake system, hoses, tires and wheels for damage
□	Check underside of vehicle for fluid leaks and loose components
□	Install wheel locks (if equipped)
□	Install wheel bolt covers and center caps as supplied*
□	Inspect wheel bolts for proper torque*
□	Set and store tire pressures for either sold vehicle OR stock inventory vehicle*
Driving Performance
□	Check horn operation
□	Verify hold and release of electronic parking brake
□	Verify engine Start-Stop System functionality*
□	Verify engine performance and acceleration*
□	Verify transmission operation, including shift paddles (if equipped)
□	Test drive vehicle applying brakes several times*
□	Check adaptive air suspension in all positions (if applicable)
□	Check steering / tire alignment
□	Check for squeaks, rattles and wind noise. Repair any squeaks, rattles or wind noises before delivery to the customer
□	Calibrate rear view mirror*
□	Verify quality of radio reception in AM / FM / SiriusXM® bands
Driver Assistance
□	Verify cruise control / ACC with Stop & Go functionality (if equipped)
□	Verify Audi side assist functionality (if equipped)
□	Verify Audi side assist functionality Pre sense® rear (if equipped)
□	Verify Audi active lane assist functionality (if equipped)
□	Verify operation of parking system (if equipped)*
□	Verify operation of Traffic Sign Recognition (if equipped)
□	Verify all vehicle Head-up display functionality (if equipped)*
□	Verify operation of High beam assist
□	Activate NAV and follow directions back to dealership (if equipped)
Post-Road Test Inspection
□	Verify SOS button is green and Roadside assistance button LED will remain off
□	- It may take up to 20 minutes for the emergency call system to activate (LED turns green) after flight/transport mode deactivation
□	- The vehicle must not be delivered to the customer if the emergency call function has not been successfully activated (LED lights up in green)
□	Interrogate fault memory and upload diagnostic log to GFF Paperless Server
□	Check service interval and verify correct interval is displayed
□	Check engine oil level*
□	Check all fluid levels and top off if necessary
□	Ensure the yellow tire pressure tag is installed on the steering wheel
□	Apply 30 Day Inventory Maintenance Sticker**
□	Install showroom charger to ensure battery remains charged at all times**

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery.


_{Technician Signature}	_{Last 8 of VIN}	_{Completion Date}