LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Charging System (Battery, Starter, Generator) & Cruise Control (Battery & Adaptive Cruise Control)) >> 27 Battery, Starter, Generator, Cruise Control >> Starter >> Starter, Removing And Installing >> Starter, Removing And Installing, With 4-Cylinder Engine >> Installing

Starter, Removing And Installing, With 4-Cylinder Engine: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Bolt & Spacer Sleeve
GWWA34-10501Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

CAUTION:

There is a risk of damaging the starter through improper handling.

- Tighten the bolt only with the spacer sleeve installed between the starter and the transmission.

-- Connect the battery. Required actions. Refer to Connecting .

scientia non olet · About LEMON Manuals