GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition.

-- Remove the luggage compartment floor.

-- Market-specific: remove the front luggage compartment floor. Refer to LUGGAGE COMPARTMENT FLOOR, REMOVING AND INSTALLING .

Q5 TFSIe:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the impact protector -2-.

Continuation for All:

-- If the nut -6- for the ground cable is not accessible, remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING and remove the mount for the vehicle tool kit.

Courtesy of AUDI OF AMERICA, LLC

-- Open the cover -2- over the battery negative terminal.

-- Loosen the nut -3- several turns and remove the battery ground cable terminal clamp from the battery terminal.

-- Disconnect the connector -5-.

-- Remove the nut -6- and remove the ground cable -1- with the Battery Monitoring Control Module -J367- -4-.