Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- When the ignition and electrical equipment are switched off, connect the battery in the following sequence:
-- First connect the battery positive cable terminal to the battery positive terminal "+" by hand and tighten the nut.
-- Connect the battery ground cable terminal clamp to the battery negative terminal "-" by hand and tighten the nut.
-- Attach the cap until it engages audibly.
-- Connect the connector.
-- Check the battery for secure fit after installation.
-- Connect the Battery -A- and re-energize the 48V system. Refer to BATTERY, DISCONNECTING AND CONNECTING, 0K4 AND VH2 .
-- If the Battery, 48 V -A6- was replaced, the new Battery, 48 V -A6- must be adapted.