Wiper Arm, Adjusting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
-- Remove the wiper arm. Refer to WINDSHIELD WIPER ARM, REMOVING AND INSTALLING .
-- Switch the ignition on.
-- Activate "rear wiping" and let the wiper arm run to end position.
-- Switch off the ignition.
-- Position the wiper arm with the wiper blade mounted on the windshield wiper axle and align the wiper blade to the rear window as follows:
- Dimension -a- = 19 + 5 mm.
TIP:
The dimension is the distance between the wiper blade tip and the lower edge of the window.
-- Tighten the wiper arm nut.
-- Switch the ignition on.
-- Activate "rear wiping" and let the wiper arm run to end position.
-- Check the wiper arm adjustment again and correct if necessary.
Tightening Specifications