Windshield Wiper Arm, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch the ignition on.

-- Activate "rear wiping" and let the wiper arm run to end position.

-- Switch off the ignition and all electrical equipment. Place the ignition key outside of the vehicle.

-- Carefully expand the cap in direction of -arrows- and lift off.

Fig 1: Identifying Cover

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the washer nozzle -2-.

Fig 2: Identifying Spray Jets And Hex Head Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -1- one turn.

-- Install an M6 nut -4- on the nut.

Courtesy of AUDI OF AMERICA, LLC

-- Position the :T10369/2 on the windshield wiper arm -1- as shown.

-- Position the thrust piece -2- on the windshield wiper axle.

-- Turn the bolt -3- clockwise until the windshield wiper arm is removed from the windshield wiper axle.

-- Remove the nut completely and remove the wiper arm.