Bumper Cover, Removing And Installing: Removing

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Open the luggage compartment side trim panel cover.

-- Remove the nuts -arrow- using the : T40078  .

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -2 and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness -1-.

-- Remove the rear wheel cover. Refer to WHEEL COVER, REMOVING AND INSTALLING, REAR .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

TIP: 

• On vehicles with trailer hitch the trailer hitch must be retracted.
• The quantity of bolts -arrows- varies depending on the model.

-- Remove the bolts -1 and 4-.

Courtesy of AUDI OF AMERICA, LLC

-- Using the : T10383/1  unclip the bumper side section -3- from the body.

-- Disengage the side piece -2- on the side panel outward -arrow A- and remove the bumper cover slightly toward the rear -arrow B- with the help of a second technician.

-- Release the catches from the outside -arrows- and push the grommet -1- inward.

Courtesy of AUDI OF AMERICA, LLC

-- Guide out the wiring harness with the grommet at the body pass through.

-- Lay the bumper cover on a soft surface.