Auxiliary Radiator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connector -3- for the Charge Air Pressure Sensor -G31-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1- and remove the air duct pipe.

-- Remove the left front wheel housing liner and left wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Loosen the hose clamp -1- free up the charge air cooler and remove the left air duct pipe from the charge air cooler.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the air duct -1- in direction of -arrow- and leave in the installation position.

Fig 1: Identifying Front Bumper Cover

Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the coolant hoses -1- with the :3094 remove and free up.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -3- and bolts -2- and remove the auxiliary radiator with the bracket.

-- Remove the bolts -arrows- and remove the auxiliary radiator -1- from the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC