Overview - Radiator/Radiator Fan
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator
- Removing and Installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- After replacing, replace entire amount of coolant
- Plug
- Not available separately.
- Do not open
- O-Ring
- Not available separately.
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Rings
- Replace if damaged or leaking
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- Coolant Ventilation Line
- To the coolant expansion tank
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Ring
- Replace if damaged or leaking
- Rubber Bushing
- For the radiator
- Sleeve
- Retaining Pin
- Disengage and remove using the screwdriver
- Air Duct
- Rubber Bushing
- For the radiator
- Radiator Bracket
- Bolt
- 5 Nm
- Backing Plate
- Bolt
- 4.5 Nm
Connect the Connector Coupling
-- Replacing the damaged clip -4-.
-- Replace the damaged O-ring by removing the O-ring -2- from the connector coupling -3- with a suitable tool (do not use a sharp tool). While doing this, make sure the connector coupling and the O-ring seat are not damaged.
-- Moisten the new O-Ring with coolant.
-- Press the connector coupling -3- onto the connection -1- until it engages audibly.
-- Push the connector coupling on again and pull it to make sure the connector coupling is engaged correctly.