Coolant Recirculation Pump -V50-, REMOVING AND INSTALLING, AUDI A6/A7: Removing
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- During installation, all heat shield boots must be installed at the same location.
-- Remove the coolant pipe for the transmission. Refer to TRANSMISSION COOLANT PUMP, REMOVING AND INSTALLING .
-- Remove the heat shield boot.
-- Disconnect the connector -4-.
-- Place a cloth underneath to catch any escaping coolant.
-- Lift the clamps -3 and 5- and remove the coolant hoses.
-- Remove the bolts -2- and remove the Coolant Recirculation Pump -V50- with the bracket.
-- If the pump should be replaced, remove the bolts -1- and remove the bracket.