LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Cooling System [DMTA,DPAA,DPUA,DPVA,DMTC]) >> 19 Cooling System >> Coolant Pump/Coolant Thermostat >> Coolant Pump, Removing And Installing >> Removing

Coolant Pump, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to DRAIN THE COOLANT .

Audi A6/A7 with Particulate Filter:

GWWA19-12885Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness.

-- Lift the clamps -1 and 2-, remove and free up the coolant hoses.

-- Disconnect the connector -4- for the Engine Coolant Level Sensor -G32-.

-- Remove the bolt -3- and remove the coolant expansion tank.

All Audi A6/A7:

GWWA19-11988Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -2- and remove the coolant hose.

-- Lift the clamp -1-, loosen the hose clamp -2- and remove the coolant hoses.

GWWA17-11177Courtesy of AUDI OF AMERICA, LLC

-- Unlock the catch in direction of -arrow A- and release in direction of -arrow B-, and remove the vacuum hose.

GWWA10-12323Courtesy of AUDI OF AMERICA, LLC

Continuation for All Vehicles:

GWWA15-11643Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -2 to 5-.

Audi A6/A7

GWWA17-11041Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and move the bracket -2- with the engine wiring harness to the side.

Audi A4/A5/Q5:

GWWA17-11236Courtesy of AUDI OF AMERICA, LLC

-- Free up the engine wiring harness -1-.

-- Remove the bolt -arrow- and the bracket -2-.

Vehicle Without Particulate Filter:

Fig 1: Oil Pressure Switch, Level 3 -F447- Installation Position -2-
GWWA19-11453Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Remove the bolts -arrows- and remove the toothed belt guard.

Vehicles with a Particulate Filter:

GWWA19-12803Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- for the Oil Pressure Switch, Level 3 -F447-.

-- Free up the wiring harness -3-.

-- Remove the bolts -arrows- and remove the toothed belt guard -1-.

Continuation for All Vehicles:

Fig 2: Coolant Pump - Tightening Sequence
GWWM19-10052Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

-- Remove the toothed belt from the coolant pump.