Overview - A-Pillar Trim Panel
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- A-Pillar Lower Trim Panel
- Removing and installing. Refer to LOWER A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Insert at the front in the relay and fuse panel or the carpet
- Stretch the inner door seal lip over.
- A-Pillar Gap Cover
- Removing and installing. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Clip into the A-pillar trim panels
- Stretch the inner door seal lip over.
- A-Pillar Upper Trim Panel
- Removing and installing. Refer to UPPER A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Stretch the inner door seal lip over.
- Clip
- Replace after removing the A-pillar trim panel
- With hooks
- Insert in the trim panel
- Retaining Pin
- 3.5 Nm
- Clip
- Replace damaged or deformed clips
- Insert in the trim panel
- Remove the clips that are still in the mounting points on the body using the Omega Clip Tool:T40280 .
- Clip
- Replace damaged or deformed clips
- Insert in the trim panel
- Remove the clips that are still in the mounting points on the body using the Omega Clip Tool:T40280 .
- Bolt
- 2.5 Nm
- Driver side only
- Clips
- Replace damaged or deformed clips
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool:T40280 . To install, insert into the sill panel strip.