Overview - Door Seals

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Rear Door Seals

Courtesy of AUDI OF AMERICA, LLC

Side Sill Seal
- Removing and Installing. Refer to SIDE SILL SEAL, REMOVING AND INSTALLING .
Inner Door Seal
- Removing and Installing. Refer to INNER DOOR SEAL, REMOVING AND INSTALLING .
Outer Door Seal
- Replace after removing.
- Installation position. Refer to Fig 4.
- Removing and Installing. Refer to OUTER DOOR SEAL, REMOVING AND INSTALLING .
C-Pillar Seal
- Installation position. Refer to Fig 3.
B-Pillar Seal
- Installation position. Refer to Fig 2.
Seam Seal
- Removing and Installing. Refer to SEAM SEAL, REMOVING AND INSTALLING .

B-Pillar Seal Installation Position

Fig 2: B-Pillar Seal Installation Position

Courtesy of AUDI OF AMERICA, LLC

The vehicle and the seal must be at room temperature.
The adhesive surfaces must be free of dirt and grease.
If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.

-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .

-- Apply Bonding Agent:D 355 205A2 on the adhesive surface using the Applicator:D 009 500 25 and let dry.

-- Remove the protective film, put the seal in the installation position and apply it.

Seal
Inner Door Panel
Outer Door Panel

C-Pillar Seal Installation Position

Fig 3: C-Pillar Seal Installation Position

Courtesy of AUDI OF AMERICA, LLC

-- Bring the seal into the installation position.

Seal
Outer Door Panel
Inner Door Panel

Outer Door Seal Installation Position

Fig 4: Outer Door Seal Installation Position

Courtesy of AUDI OF AMERICA, LLC

Door Body
Seal