High Pressure Sensor -G65-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Replace the O-ring seal -B-, and coat lightly with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .

-- Tighten the High Pressure Sensor -G65- -A-.

Tightening specification:

Refer to OVERVIEW - CONDENSER