Condenser, Removing And Installing, RS Models: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- For all the following work, close the open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .
-- Switch off the ignition.
-- Remove the bumper cover bracket together with the impact member. Refer to OVERVIEW - LOCK CARRIER .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Release the catches -arrow- and remove the air duct -1 and 3-.
-- Disconnect the connector -1- for the High Pressure Sensor -G65-.
-- Remove the bolt -2-.
-- Release the left and right catches -arrows-, disengage and remove the condenser on the radiator.