Condenser, Removing And Installing, All Except RS Models: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- For all the following work, close the open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .
-- Switch off the ignition.
-- Discharge the refrigerant circuit. Refer to Refrigerant Circuit or Working with A/C Service Station .
-- Remove the lock carrier cover and front bumper end panel. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- On vehicles with an electric radiator shutter, remove it. Refer to RADIATOR SHUTTER, REMOVING AND INSTALLING .
-- Release the catches -arrow- and remove the air ducts -1 and 3-.
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Disconnect the connector -2- for the High Pressure Sensor -G65-.
-- Release the left and right catches -arrows- and disengage the condenser -1- from the radiator and remove downward.