Right Temperature Control Door Motor -V159-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the right front seat all the way to the rear.
-- Switch off the ignition.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR DUCT FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Remove the right footwell vent. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Remove the Right Side Vent Motor:V300 . Refer to Right Side Vent Motor -V300-, REMOVING AND INSTALLING .
-- Label the connector -C- (to prevent a mix up if several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Disconnect the connector -C-.